2014-02-28T23:30:29Z PunBB https://www.soliforum.com/topic/5679/need-e3d-help/ Still haven't  got control of repetier yet.  Only home buttons. I cant turn my bed heater on.  I uninstalled repetier and reinstalled 09.5. And still have same problem.  When I changed to e3d I didn't change anything on board. I used same cord on power supply when  I changed that out also

]]> https://www.soliforum.com/user/739/ 2014-02-28T23:30:29Z https://www.soliforum.com/post/51153/#p51153 Re: Z-Stop Just put the screw in from the bottom.
Re: Loose fan shroud If it bothers you put a small hole in each side near the rear of the shroud and run a wire through and twist the ends together.

]]> https://www.soliforum.com/user/2291/ 2014-02-24T02:04:10Z https://www.soliforum.com/post/50689/#p50689 Didn't work.    Maybe it's repieter  and the update I did. I'll put all my stls in a folder and reinstall
How much would you charge me for a mk5

]]> https://www.soliforum.com/user/739/ 2014-02-24T01:56:40Z https://www.soliforum.com/post/50688/#p50688 I noticed sometimes  that the x/y wont work til I heat the bed a bit, have you tried that? If you can get it to work,print the MK5. it has tabs on both sides ,rt side is for x stop screw. put a screw on the left.That stopped the fan shroud from spinning

]]> https://www.soliforum.com/user/574/ 2014-02-23T22:54:06Z https://www.soliforum.com/post/50679/#p50679 Have sd2. Installed  mk4/ e3d / updated to repieter  vo.90c.  I was running older version that was out jan 13.   Before firmware update it said to make sure printer manual controls work.
None of x and y  and z buttons work but home buttons work. ,  any ideas?  Plus. The the  fan motor and shroud is loose on e3d .  How do they tighten those up so they don't swivel around.
The e3d fit pretty good into mk4 but will have to do a z stop extender .

]]> https://www.soliforum.com/user/739/ 2014-02-23T20:19:09Z https://www.soliforum.com/post/50676/#p50676