the start up Gcode in Slicer and it dosent execute what i put in there! i saved it and made sure those were the selections i had for slicing, it just dosent do it!

Thats where you put it - Slicer Configuration->Printer Settings->Custom G;Code .
Make sure you save it, and that you have that printer profile selected in the Slic3r tab .

Separately, but worth noting -slic3r will ignore any temps set via 'Filament' tab for first layer, bed temp, etc if you have any temp commands in your custom start code - so I leave all the m109 etc out of the custom code (including just commented out - that broke in some slic3r versions) and set all temps via the filament tab..

and on a separate note. i see you have custom startup G code where do you have that saved at , cause i added some stuff to the start up Gcode in Slicer and it dosent execute what i put in there! i saved it and made sure those were the selections i had for slicing, it just dosent do it!

all i tried to add was M42 P8 S255  so i could turn on the fans i have there i wouldnt mind have the extrude anchor in there too

There is a slight error in the model; which I repaired in the attached STL.. but otherwise, works fine with 3 layers of raft..

the inner ring keeps coming detached from the bed before it gets a chance to stableize itself by bridging to the outer part. so ive been tryingto enable the raft option and no matter what when i slice it it just dosent add the raft!  ivve tried 1-3 layers of raft, and even tried slicing with the standalone slicer program and importing the Gcode, still no raft?! anyone else having this problem?