<![CDATA[SoliForum - 3D Printing Community — Layers too far apart]]> 2014-02-22T03:21:06Z PunBB https://www.soliforum.com/topic/5654/layers-too-far-apart/ <![CDATA[Re: Layers too far apart]]> Can you share a picture?
I had quite a few voids in many prints until recently. With my problem, I went into RH and tweaked my setting per print. Most recently, I measured my current filament with a caliper (1,78mm), went into Repetier, and saw the stock setting was 3mm. This would mean that my extruder was not applying enough filament, leaving holes.
Also, calibrate your bed. Level it, make sure the hotend is a MetraCard/CTA card/business card away from the bed. There is a useful Solidoodle instruction on Vimeo.com. Just look up Solidoodle and scroll.

After I did all that, I've been getting quality prints.
As a recommendation, but a square of glass from a local shop and use it as a bed if you have not.

]]> https://www.soliforum.com/user/4188/ 2014-02-22T03:21:06Z https://www.soliforum.com/post/50498/#p50498 <![CDATA[Layers too far apart]]> Ive been working on getting my prints fine tuned, I havent been able to take a picture but the layers seem to be too far apart or too thin. I was able to pour liquid on top and it instantly fell through. Any advice on how to get the lines closer together.

Thanks in advanced!

]]> https://www.soliforum.com/user/1200/ 2014-02-22T02:31:55Z https://www.soliforum.com/post/50495/#p50495