Clean up takes awhile and this was my 2nd attempt at the Gyro The Cube print. The first one was at 60% and it self destructed when removing the supports. I had sliced it with KISSlicer and used  a 20% infill. So, I decided it must be the infill and size, so I made it at 100% size with solid infill. Unfortunately, the sides split right along the horizontal layer lines on the most narrow section. I really don't think this one can be printed and survive with the SD2 ABS red I have.

That said, there's one here that says it is thicker, that I may try next. It's called the Big Thick Gyro Cube v2.

-- ggunners