SoliForum - 3D Printing Community — YSB print bust of "The Huntress" and friend

Re: YSB print bust of "The Huntress" and friend

2014-02-11T19:17:52Z

ggunners wrote:

Printed another YSB subject bust of The Huntress.
Made this one at 80% of actual and .200 mm layer height. After looking at the 3D image, the chin of the large cat seemed to be hanging in space, so I decided to print it with supports and used KISSlicer.
It turned out pretty well except from the Huntress upper lip upward, I had more visible banding than below that point. I'm not sure why it became a bit worse at that height. Overall, I am very happy with the print. -- ggunners

Nice job

Re: YSB print bust of "The Huntress" and friend

2014-02-11T13:06:10Z

...yes... the inferior jaws slope of the panther is a bit too much for 0.2mm...but it can be printed ...i think i do it with 0.18mm layers, it's not a lot less but that do the trick...

dispite this, nice print ...

ps: I just finished building my new printer yesterday ... "THE" project will finally be able to advance

YSB print bust of "The Huntress" and friend

2014-02-10T21:43:21Z

Printed another YSB subject bust of The Huntress.

Made this one at 80% of actual and .200 mm layer height. After looking at the 3D image, the chin of the large cat seemed to be hanging in space, so I decided to print it with supports and used KISSlicer.

It turned out pretty well except from the Huntress upper lip upward, I had more visible banding than below that point. I'm not sure why it became a bit worse at that height. Overall, I am very happy with the print. -- ggunners