<![CDATA[SoliForum - 3D Printing Community — Vertical configuration extrusion speed question]]> 2014-02-06T15:01:48Z PunBB https://www.soliforum.com/topic/5445/vertical-configuration-extrusion-speed-question/ <![CDATA[Re: Vertical configuration extrusion speed question]]> Had a chance to look at the pictures.

I think it's due to the difference in pellet feed. When you're feeding behind the flange, you're using a smooth tube with no flat section. When you're feeding through the normal hopper, there's a flat section so the pellets don't feed as well. This one should work better:

http://www.thingiverse.com/thing:225810

]]> https://www.soliforum.com/user/221/ 2014-02-06T15:01:48Z https://www.soliforum.com/post/48841/#p48841 <![CDATA[Re: Vertical configuration extrusion speed question]]> Pictures?

]]> https://www.soliforum.com/user/221/ 2014-02-06T05:28:32Z https://www.soliforum.com/post/48819/#p48819 <![CDATA[Vertical configuration extrusion speed question]]> I have my filastruder mounted vertically with Ian Johnsons vertical hopper. I sanded the inside of the hopper and have a question.
When I run the filastruder I get 8 inches per minute normally. If I put pellets into the auger from on top of the auger where it is exposed between the flanges I can get over 12 inches per minute.
your thoughts please.
Thanks

]]> https://www.soliforum.com/user/99/ 2014-02-06T02:07:18Z https://www.soliforum.com/post/48796/#p48796