2014-02-03T01:53:15Z PunBB https://www.soliforum.com/topic/5399/prints-coming-apart-because-they-are-too-stingy/ 180 is more than high enough for PLA.  Try calibrating your flow rate http://solidoodletips.wordpress.com/201 … flow-rate/

]]> https://www.soliforum.com/user/1142/ 2014-02-03T01:53:15Z https://www.soliforum.com/post/48498/#p48498 i was printing at 195 so i raised it to 200 with no difference am i printing at too high a temp ? I read that white pla is good at 180 degrees

]]> https://www.soliforum.com/user/4695/ 2014-02-02T23:41:27Z https://www.soliforum.com/post/48494/#p48494 Yeah, for better bonding between layers try raising the temp a few degrees as long as the extrusion and flow rates are calibrated.

]]> https://www.soliforum.com/user/296/ 2014-02-02T05:18:28Z https://www.soliforum.com/post/48439/#p48439 Hi so I just finished the spool mount and while it was printing i notice the layers were a bit stringy, afterwards when trying to take the piece of it came apart and was very weak. I am printing with white PLA on a non heated bed what could be the cause ? im guessing temp. because i just started using pla and i am trying to find the right temperature to print with it , any other suggestions welcomed

]]> https://www.soliforum.com/user/4695/ 2014-02-02T03:26:19Z https://www.soliforum.com/post/48431/#p48431