<![CDATA[SoliForum - 3D Printing Community — Extruder Calibration makes no sense???]]> 2014-01-27T00:25:09Z PunBB https://www.soliforum.com/topic/5321/extruder-calibration-makes-no-sense/ <![CDATA[Re: Extruder Calibration makes no sense???]]> I usually set 130 for Feed+Flow...though I have the best prints at 140 for each. I haven't seen much online as to Feedrate and Flowrate settings, so mine are entirely from empirical observation. I think Fedde and I are a short string of new RH issues....I think this is a pretty massive one though.

If ANYONE can tell me anything I am doing wrong, even with Feed+Flow, I would massively appreciate!
And thank you for the fast responses! smile

]]> https://www.soliforum.com/user/4188/ 2014-01-27T00:25:09Z https://www.soliforum.com/post/47815/#p47815 <![CDATA[Re: Extruder Calibration makes no sense???]]> Ahhh, might be something in rh95f messing up a setting related to extrusion or flow then....

I haven't had time to get rh95f so can't be sure, but sounds like it.

]]> https://www.soliforum.com/user/296/ 2014-01-26T23:58:23Z https://www.soliforum.com/post/47812/#p47812 <![CDATA[Re: Extruder Calibration makes no sense???]]> Did on me to, i overextrudet 35mm, noticed a small quality improvement.

You should calibrate flow rate too, and set the diameter of the fillament, if you havent alleready.

]]> https://www.soliforum.com/user/2918/ 2014-01-26T23:54:54Z https://www.soliforum.com/post/47811/#p47811 <![CDATA[Re: Extruder Calibration makes no sense???]]> maybe post up your settings in RH for the extruder.

]]> https://www.soliforum.com/user/296/ 2014-01-26T23:54:07Z https://www.soliforum.com/post/47810/#p47810 <![CDATA[Re: Extruder Calibration makes no sense???]]> Your overextruding can also be mitigated by the flow rate settings.

]]> https://www.soliforum.com/user/296/ 2014-01-26T23:53:33Z https://www.soliforum.com/post/47808/#p47808 <![CDATA[Extruder Calibration makes no sense???]]> scratching my head on this...
I recently download RH 95F. Since then, my calibrations are wwwaaaaayyyyyy off.
Always using Ian's video as the gospel, I've had luck.
But here's my dilemma:
   EEPROM set at 109.5
   Set extrude to 100 then extrude
   Over extrudes by 40mm
   After math ( 10,950 divided by 140= 78.214blah blah blah

This does not seem right as I can tell from previous prints I HAVE been over extruding...but not by THAT much! haha

Any suggestions??

]]> https://www.soliforum.com/user/4188/ 2014-01-26T23:24:00Z https://www.soliforum.com/post/47804/#p47804