<![CDATA[SoliForum - 3D Printing Community — Help Me Dial In]]> 2014-01-16T16:21:38Z PunBB https://www.soliforum.com/topic/5200/help-me-dial-in/ <![CDATA[Re: Help Me Dial In]]> Bed at 200, extruder at 100

]]> https://www.soliforum.com/user/4604/ 2014-01-16T16:21:38Z https://www.soliforum.com/post/46947/#p46947 <![CDATA[Re: Help Me Dial In]]> what temp do you have the extruder set to?

]]> https://www.soliforum.com/user/644/ 2014-01-16T15:50:42Z https://www.soliforum.com/post/46944/#p46944 <![CDATA[Re: Help Me Dial In]]> Adjusted the multiplier. Went from .75 to .70

Printed the key again, scaled slightly up, at .1 mm. Still need to trim some of the brim off in places, and there are definitely artifacts

]]> https://www.soliforum.com/user/4604/ 2014-01-16T15:43:14Z https://www.soliforum.com/post/46940/#p46940 <![CDATA[Re: Help Me Dial In]]> I'll give that a try. Anything else?

]]> https://www.soliforum.com/user/4604/ 2014-01-15T21:36:04Z https://www.soliforum.com/post/46864/#p46864 <![CDATA[Re: Help Me Dial In]]> Looks like you are still over extruding.  try dialing back the Extrusion multiplier a little

]]> https://www.soliforum.com/user/644/ 2014-01-15T17:32:04Z https://www.soliforum.com/post/46854/#p46854 <![CDATA[Help Me Dial In]]> So far I have done the following:
- calibrated extruder and flow rate
- glass bed, leveled
- adjusted tension in belts
- acrylic enclosure

I've only printed parts for the enclosure, so I wanted to try something else. I printed the Key to Eribor from The Hobbit off Thingiverse at mostly default settings (.3 mm with support)

Tonight I'm going to bump up the resolution to see what that looks like. Any other suggestions to help me get the most out of my prints?

]]> https://www.soliforum.com/user/4604/ 2014-01-15T15:24:56Z https://www.soliforum.com/post/46846/#p46846