SoliForum - 3D Printing Community — Solid infill is a mess

Re: Solid infill is a mess

2014-01-31T06:01:14Z

the best way to change firmware settings is to use g/m codes to change the settings without messing around with the firmware. Here is a video Ian made explaining it. ---> http://www.youtube.com/watch?v=JZGdMc2ebPo

and here are some additional links to help in case ---> http://www.soliwiki.com/Main_Page#Calibrations

http://solidoodletips.wordpress.com/201 … flow-rate/

http://wiki.solidoodle.com/

Re: Solid infill is a mess

2014-01-31T00:36:37Z

Were you able to connect?

Re: Solid infill is a mess

2014-01-31T00:20:32Z

I doubt it... Your probably going to have to be a little more specific.

Re: Solid infill is a mess

2014-01-31T00:18:48Z

I cant access this for some reason, does that mean I have to update my firmwire?

Re: Solid infill is a mess

2014-01-16T01:26:22Z

As promised

Re: Solid infill is a mess

2014-01-16T00:31:09Z

I'll send a screenshot in about 30 minutes working from my phone.

Re: Solid infill is a mess

2014-01-16T00:17:38Z

I have not calibrated my extruder. What is EEPROM

Re: Solid infill is a mess

2014-01-14T15:35:54Z

Have you calibrated your extruder? Look at EEPROM Settings and lower E: closer to 100.

Re: Solid infill is a mess

2014-01-14T08:56:33Z

The problem only really gets bad if there is like 3 or more solid infills on top of each other.

Solid infill is a mess

2014-01-14T08:24:10Z

Hello,

My solid infill seems to be extruding too much i think. Every time my print gets to a piece that needs to give to use a solid infill it gets messy.

I am not sure what part of slicer i need to change to fix this.

infill density: .1
infill every 1 layer
solid fill every 0 layers
solid infill threshold 70

solid infill speed 15

Solid infill (under advanced): 0