<![CDATA[SoliForum - 3D Printing Community — Smooshing and Plowing]]> 2012-11-13T22:42:30Z PunBB https://www.soliforum.com/topic/518/smooshing-and-plowing/ <![CDATA[Re: Smooshing and Plowing]]> Yes it looks like to me that the nozzle is plowing up the ABS

Z axis screwed up or not moving up/down correctly orr backlash

Looks like it is happening on the bed (bottom of cup)
and 10mm up (top of peg)


chuk wrote:

I have very limited experience with these things but is the tip of the extruder actually digging up the layer as it moves across it?

]]> https://www.soliforum.com/user/264/ 2012-11-13T22:42:30Z https://www.soliforum.com/post/4524/#p4524 <![CDATA[Re: Smooshing and Plowing]]> I have very limited experience with these things but is the tip of the extruder actually digging up the layer as it moves across it?

]]> https://www.soliforum.com/user/151/ 2012-11-13T02:06:58Z https://www.soliforum.com/post/4487/#p4487 <![CDATA[Re: Smooshing and Plowing]]> Backlash in Z can cause the first couple of layers to be shorter than they are supposed to be.  I would think that it looks like they are over extruded, except that the there are gaps between the threads.  If flow was too high, the threads would be touching.

The peg looks like the problem might be cooling.  Everything is getting shoved around because it is still hot and soft when the next layer goes on.  Set the minimum layer time in cool settings to something like 10.

]]> https://www.soliforum.com/user/14/ 2012-11-12T23:25:42Z https://www.soliforum.com/post/4482/#p4482 <![CDATA[Re: Smooshing and Plowing]]> Buy a Solidoodle  wink

]]> https://www.soliforum.com/user/78/ 2012-11-12T23:16:56Z https://www.soliforum.com/post/4480/#p4480 <![CDATA[Smooshing and Plowing]]> I can't get my Orbot Hadron to print anything nicely?
Here are clear ABS prints ET 200 BT 85
Repetier 070

Looks like I have z axis calibration problem this is using 2760 steps/mm
done by calibration

Any suggestions

Top of peg seems to get smooshed
I can't get my Orbot Hadron to print anything nicely?
Here are clear ABS prints ET 200 BT 85
Repetier 070

Looks like I have z axis calibration problem this is using 2760 steps/mm
done by calibration

Any suggestions

Top of peg seems to get smooshed

Peg_226.jpg
    Smooshed Peg

Bottom of cup gets plowed away

Cup241.jpg
    Bottom of cup gets plowed

Cup245.jpg
    Plowed bottom of cup

]]> https://www.soliforum.com/user/264/ 2012-11-12T23:04:04Z https://www.soliforum.com/post/4479/#p4479