SoliForum - 3D Printing Community — Any hard calibration before I can print?

Re: Any hard calibration before I can print?

2014-01-06T05:48:38Z

HaroldDavid wrote:

Thanks Ronsii! The calibration seems hard, is there any videos? I'am a newbie

Oh, sorry I thought there were links in the first link leghk put up anyways there should be links to vids on the last link... I know one of the wiki sites has them.

Re: Any hard calibration before I can print?

2014-01-06T02:15:36Z

I think this may help - http://wiki.solidoodle.com/first-layers … e-z-offset

Re: Any hard calibration before I can print?

2014-01-05T09:39:29Z

Thanks Ronsii! The calibration seems hard, is there any videos? I'am a newbie

Re: Any hard calibration before I can print?

2014-01-05T05:40:59Z

Hi HaroldDavid, Like Leghk said first check the Z tab the only other know issue is the extrusion rate is usually about 30 percent over but it is best to check all the calibrations just to be on the safe side

Re: Any hard calibration before I can print?

2014-01-05T04:35:24Z

Thanks everyone!

Re: Any hard calibration before I can print?

2014-01-05T04:11:49Z

http://www.soliwiki.com/#Calibrations

Do the Z stop calibration before you try to print anything, just for safety's sake to prevent any chance of crashing the extruder into the build platform.

The rest of the listed calibrations will improve your results.

Re: Any hard calibration before I can print?

2014-01-05T04:02:20Z

I'm getting my printer in about a week or two, but from my knowledge it does come with a power supply, and to see if you need any calibration you would just need to start a print and see what needs tuning.

Any hard calibration before I can print?

2014-01-05T03:05:10Z

Hi all, I was wondering if there is any need for calibration before I can start printing on the Solidoodle 2 Base. Is a power supply included in the package? Thanks!