<![CDATA[SoliForum - 3D Printing Community — Partial clog?]]> 2012-11-15T22:07:27Z PunBB https://www.soliforum.com/topic/506/partial-clog/ <![CDATA[Re: Partial clog?]]> good advice

]]> https://www.soliforum.com/user/7/ 2012-11-15T22:07:27Z https://www.soliforum.com/post/4710/#p4710 <![CDATA[Re: Partial clog?]]> Jason wrote:

Darn, I have been printing very successfully so I avoided asking the question. 

Do you think it's a clog in the nozzle?  If so what is the best route to clear it?

Guitar string. It's probably a tiny bit in the nozzle. Better to clean it out now before it gets worse.

]]> https://www.soliforum.com/user/221/ 2012-11-10T22:06:02Z https://www.soliforum.com/post/4389/#p4389 <![CDATA[Re: Partial clog?]]> Darn, I have been printing very successfully so I avoided asking the question. 

Do you think it's a clog in the nozzle?  If so what is the best route to clear it?

]]> https://www.soliforum.com/user/26/ 2012-11-10T21:32:09Z https://www.soliforum.com/post/4387/#p4387 <![CDATA[Re: Partial clog?]]> I would say yes.

I have the same issue at the moment, and it will only extrude for a few seconds before the filament backs up and strips in the extruder.

]]> https://www.soliforum.com/user/51/ 2012-11-10T21:21:16Z https://www.soliforum.com/post/4386/#p4386 <![CDATA[Partial clog?]]> When I click extrude my filament always curls up and sticks to the hot end.  Is this an indication of a partial clog or is it normal?  It has done this since day one when I had trouble removing the piece of filament that was left in during shipping.

http://www.soliforum.com/misc.php?action=pun_attachment&amp;item=323

]]> https://www.soliforum.com/user/26/ 2012-11-10T21:13:47Z https://www.soliforum.com/post/4385/#p4385