<![CDATA[SoliForum - 3D Printing Community — Rumba Controller Switchover?]]>2014-01-01T16:24:47ZPunBBhttps://www.soliforum.com/topic/5025/rumba-controller-switchover/<![CDATA[Rumba Controller Switchover?]]>Okay, So I shorted my Rev-E Motherboard back before christmas and STILL have not recieved a replacement from them. It is beyond aggravating. So I figured I might as well make some improvements! I have done a LITTLE Research, and so far I think im going to go with the Rumba. Is this going to basically just be plug in, install drivers, and play? I would love to get back to printing ASAP. Any help/advice/suggestions are definitely welcome! Thanks! I was looking at this board: http://www.reprapdiscount.com/electroni … board.html Will I need to buy these for it or are they built in? http://www.reprapdiscount.com/electroni … river.html