SoliForum - 3D Printing Community — Very ugly artifacts when printing

Re: Very ugly artifacts when printing

2013-12-19T10:18:38Z

COASTER19 wrote:

The artifacts do not appear in the g-code visualization, so I'd be very surprised if this were the stl or slicers fault. I've never seen anything like this however, so don't totally rule them out. Have you seen this behavior on any other prints?

Yes, on the other prints I see the same things. Apparently it began after I switch from the use of Pronterface to the Repetier-Host, it can be?

Re: Very ugly artifacts when printing

2013-12-18T22:58:13Z

The artifacts do not appear in the g-code visualization, so I'd be very surprised if this were the stl or slicers fault. I've never seen anything like this however, so don't totally rule them out. Have you seen this behavior on any other prints?

Re: Very ugly artifacts when printing

2013-12-18T19:15:02Z

Briggs wrote:

3d, did you run your stl through Netfab first?

Why Netfab? This issue happened with all similar models, directly downloaded from thingiverse, and with my own-maded. For .stl repairing i use Materialize Magics. How Netfab can help me in this case?

Re: Very ugly artifacts when printing

2013-12-18T18:39:41Z

3d, did you run your stl through Netfab first?

Very ugly artifacts when printing

2013-12-18T09:35:51Z

Appear on the surface with a small reverse bias. Has anyone seen anything similar?
Use Slic3r 1.0.0RC1 and Repetier-Host from last Solidoodle package download.
Thread when printing does not sag, does not fall, it's okay.