<![CDATA[SoliForum - 3D Printing Community — tolerance for holes]]> 2013-12-17T13:36:22Z PunBB https://www.soliforum.com/topic/4891/tolerance-for-holes/ <![CDATA[Re: tolerance for holes]]> If I am trying to make something that slides together nicely(loose enough that glue would be needed to insure it stays in place), I usually use .2-.3mm for tolerances. Make sure you do all your calibrations.

http://www.soliwiki.com/#Calibrations
http://www.thingiverse.com/thing:84795

]]> https://www.soliforum.com/user/1906/ 2013-12-17T13:36:22Z https://www.soliforum.com/post/44507/#p44507 <![CDATA[tolerance for holes]]> I must insert cylindrical magnets (diameter 2mm, height 2mm) into holes of an alumide model. I made a hole of exactly 2mm (see screenshot), which was stupid since I should have known that it would be impossible to get the magnet into the hole. What do you think would be a reasonable tolerance? 2.2mm? Also, should I produce a slightly tapered hole in order to facilitate the insertion? Many thanks for your help!

]]> https://www.soliforum.com/user/4359/ 2013-12-17T12:53:08Z https://www.soliforum.com/post/44503/#p44503