2013-12-18T06:32:12Z PunBB https://www.soliforum.com/topic/4889/what-causes-protruding-corners/ increase jerk, which is the instantaneous velocity more or less. Lower jerk creates more ooze on corners.

]]> https://www.soliforum.com/user/663/ 2013-12-18T06:32:12Z https://www.soliforum.com/post/44601/#p44601 I would bet more that its over extrusion on corners in your case, as the over extrusion is roughly symmetric. If it is speed related, only one wall of the conner will be protruding, not both.

]]> https://www.soliforum.com/user/221/ 2013-12-17T20:31:23Z https://www.soliforum.com/post/44548/#p44548 I imagine it has something to do with acceleration settings or jerk settings.  Though I do not quite understand the difference.  As I mentioned, I lowered the acceleration which had no effect.

]]> https://www.soliforum.com/user/3018/ 2013-12-17T20:30:11Z https://www.soliforum.com/post/44547/#p44547 I had read previously that it's related to speed, but in my experience, that's not the case! I would like to find out as well!

]]> https://www.soliforum.com/user/48/ 2013-12-17T18:07:48Z https://www.soliforum.com/post/44533/#p44533 My corners are never square.  They always protrude a little bit.  I tried dialing down the perimeter acceleration to 200 while keeping the other accelerations at 1000.  I could physically see the carriage slow down at the corners so I know it was working, but there was zero effect on the protrusion problem.  Is there a way to eliminate this artifact?  It forces me to have to shave down all of my prints which is not fun:(

]]> https://www.soliforum.com/user/3018/ 2013-12-17T04:59:05Z https://www.soliforum.com/post/44490/#p44490