SoliForum - 3D Printing Community — question on bridges

Re: question on bridges

2014-01-16T07:56:06Z

Bump..just want to hear others thoughts

Re: question on bridges

2014-01-03T00:44:19Z

I had to set mine at 10mm.
and why dont it use bridge setting on most short bridges say under 20mm long?

Re: question on bridges

2013-12-18T04:31:28Z

satman49 wrote:

I just printed that stl , came out pretty well.Had to do a bit of clean up.I used 55mm for bridges.

55mm/s it won't anchor. maybe 200C for temp is not enough

Re: question on bridges

2013-12-16T01:53:29Z

I just printed that stl , came out pretty well.Had to do a bit of clean up.I used 55mm for bridges.

question on bridges

2013-12-15T11:59:09Z

Is it weird that I get my best bridges so far (on bridge torture test.stl) when it's bridging at 15mm/s ??

Everything I've heard says that faster is better for bridges, at least 60mm/s +. But when I use fast speed for bridging, it doesn't anchor the bridge strands in good enough and they snap off near the perimeters of where they are anchored to.