SoliForum - 3D Printing Community — extruder anchor

Re: extruder anchor

2013-12-11T03:38:29Z

THANKS cozierad, that did the trick.

Re: extruder anchor

2013-12-10T23:58:25Z

I am confused(lol not hard to do) , where would I change that? Being that I updated the firmware( was ok before that), I was thinking it might be a value change in Marlin. I have looked but really don't know where that might be.

Re: extruder anchor

2013-12-10T21:15:54Z

satman49 wrote:

I updated the firmware for my sd3( not the newest) Still using RH 90c. Now it extrudes the anchor in the wrong place( says x 145 y 145., not in upper right corner as before.I have looked for a solution but no luck.Does anybody know what I need to change to correct that?

On an SD2 145 and 145 are correct but not for an sd3. Larger bed that is approx 200 by 200. try something closer to X 195 Y195

Re: extruder anchor

2013-12-10T17:51:22Z

Here is a representation of where it is.

Re: extruder anchor

2013-12-10T11:08:34Z

satman49 wrote:

I updated the firmware for my sd3( not the newest) Still using RH 90c. Now it extrudes the anchor in the wrong place( says x 145 y 145., not in upper right corner as before.I have looked for a solution but no luck.Does anybody know what I need to change to correct that?

X145 Y145 should be in the upper right corner. Where is it extruding instead?

extruder anchor

2013-12-10T05:40:09Z

I updated the firmware for my sd3( not the newest) Still using RH 90c. Now it extrudes the anchor in the wrong place( says x 145 y 145., not in upper right corner as before.I have looked for a solution but no luck.Does anybody know what I need to change to correct that?