2013-12-02T20:54:34Z PunBB https://www.soliforum.com/topic/4723/smallest-filament-size/ Smaller diameter filament would have the same effect on moire as a microstepping driver. (ie an improvment)

]]> https://www.soliforum.com/user/221/ 2013-12-02T20:54:34Z https://www.soliforum.com/post/43062/#p43062 No reason why, just curious.

]]> https://www.soliforum.com/user/1175/ 2013-12-02T20:34:49Z https://www.soliforum.com/post/43059/#p43059 I'm kind of curious why you would want to run filament smaller than 1.75.  Aren't most filaments either 1.75 or 3mm?  Is there some other type of material that's sold in smaller diameters?  Now a smaller nozzle I think I understand because that would get higher horizontal resolution (I think).

]]> https://www.soliforum.com/user/96/ 2013-12-02T20:31:56Z https://www.soliforum.com/post/43058/#p43058 Depends on the hotend, but 1.2mm probably won't feed very well through the pinch rollers. 1.5mm is the smallest I've run reliably.

]]> https://www.soliforum.com/user/221/ 2013-12-02T20:16:28Z https://www.soliforum.com/post/43057/#p43057 with filament that small you will probably have problems keeping it from kinking, while it will lose pressure in the melt zone it will probably still work but the output from the nozzle will be very irregular at the least.

]]> https://www.soliforum.com/user/296/ 2013-12-02T19:42:44Z https://www.soliforum.com/post/43054/#p43054 I've got a SD2 with a .42 nozzle set for 1.75mm filament.  How much smaller can I go?  Can I go 1.25mm?

]]> https://www.soliforum.com/user/1175/ 2013-12-02T19:12:18Z https://www.soliforum.com/post/43049/#p43049