SoliForum - 3D Printing Community — What bed temp do you guys use?

Re: What bed temp do you guys use?

2012-11-06T13:08:21Z

I start mine at 105, which is 120 in the center and 110 on the edges, then drop it to 90.

Re: What bed temp do you guys use?

2012-11-06T12:02:35Z

I set mine to 100, but usually get bored of waiting and start printing as soon at the readout says 85...

I've not measured what that actually is yet. but I believe it reads a little on the low side anyway.

Re: What bed temp do you guys use?

2012-11-06T03:40:51Z

Since the bed never really goes above a hundred without a towel on top of it, I just set it to 110 all of the time... Quite a few 10+ hour prints that way also.

Re: What bed temp do you guys use?

2012-11-06T03:24:14Z

I've done several 12 hour prints at 100c.

Re: What bed temp do you guys use?

2012-11-06T02:15:41Z

large footprint I'll use 90, small 100, and I vary it in between depending on size.

What bed temp do you guys use?

2012-11-06T00:32:02Z

I'm looking for suggestions as to what bed temp to use. I was running my bed at 100c but I think that might have contributed to the burnout. I'm about to try a print at 85 but that's as low as I think I could go with ABS.