SoliForum - 3D Printing Community — Object not centered on bed

Re: Object not centered on bed

2013-12-01T19:25:38Z

I have found a work around for my problem. On sli3r settings/extruder tab, I changed the Extruder offset to 50.Even tho it shows off the bed in RH/gcode tab it now prints about center.

Re: Object not centered on bed

2013-11-30T05:01:20Z

yep I do. This problem was discussed on Google groups a while back but there wasn't a definitive answer as all are not having my issue.

Re: Object not centered on bed

2013-11-30T03:20:25Z

Do you home the axes before printing? (gcode might do this already)

Re: Object not centered on bed

2013-11-30T01:33:47Z

THANKS but still no go . I have set everything like you have shown. Could it be a firmware issue as I have not updated it yet?

Re: Object not centered on bed

2013-11-29T23:01:16Z

Under Repetier Host Printer Settings , go to Printer Shape; make sure it looks like the following, Including the 'Min/max' settings...

And check Printer looks like:

Under Slic3r Config, make sure Printer Settings looks like:

That would be the first things to check.

Re: Object not centered on bed

2013-11-29T22:54:43Z

Maybe the RH bed size setting...check that.

Object not centered on bed

2013-11-29T22:49:46Z

I have posted this before,but I am still having this issue. First I am using RH .90c. If I load an object and center it then slice it, it wants to print in the upper right quadrant of the bed.I have to move it to lower left( in object placement) to get it to print in the center of the bed.Magically (sic) a while back I must have changed the right thing because it started printing correctly, now its back to its old tricks.I need to print a large 7 in pulley but this issue won't let me. Any ideas?