<![CDATA[SoliForum - 3D Printing Community — kinking after MK5 install]]> 2013-11-26T21:14:31Z PunBB https://www.soliforum.com/topic/4672/kinking-after-mk5-install/ <![CDATA[Re: kinking after MK5 install]]> ok great I will pull it apart and give it a cleaning and check the alignment. I've got an E3D coming I can't wait. I just might wait until I get it in! Thanks for your help guys!

]]> https://www.soliforum.com/user/3726/ 2013-11-26T21:14:31Z https://www.soliforum.com/post/42639/#p42639 <![CDATA[Re: kinking after MK5 install]]> Alignment is important but apart from that I've only ever had problems like in the pic if something else was wrong:

- blockage in hot end
- extrusion temp too low
- printing too fast for hot end

]]> https://www.soliforum.com/user/51/ 2013-11-26T18:48:47Z https://www.soliforum.com/post/42633/#p42633 <![CDATA[Re: kinking after MK5 install]]> I did, check alignment of the extruder gear with the peek barrel. Mine was off quite a bit. Moving it over seemed to help.

Another tip would be to slow down your printing speed.

Third, it's possible your extruder could be clogged.

I had a lot of problems with my MK5 and kinking right away. A lot of them were self induced. I tried 2 different stock hot ends and ended up ditching them for a E3D.

Worth every penny.

]]> https://www.soliforum.com/user/1682/ 2013-11-26T13:52:16Z https://www.soliforum.com/post/42613/#p42613 <![CDATA[kinking after MK5 install]]> Hey everyone.  I was wondering if anyone else had issues with filament getting twisted up on the extruder gear during a print after installing the MK5 jigsaw replacement.  Is there any thing I can do to combat it? Did I do something wrong?

]]> https://www.soliforum.com/user/3726/ 2013-11-26T11:32:50Z https://www.soliforum.com/post/42604/#p42604