<![CDATA[SoliForum - 3D Printing Community — Problems loading Solidoodle3 new firmware]]> 2013-11-22T17:15:26Z PunBB https://www.soliforum.com/topic/4623/problems-loading-solidoodle3-new-firmware/ <![CDATA[Re: Problems loading Solidoodle3 new firmware]]> are you sure you have an sanguino w/Atmega 1284P?  SD usually ships with 644P unless  previous user upgraded it.

Also the baud rate should be set at 255,000 for sanguino boards.

]]> https://www.soliforum.com/user/644/ 2013-11-22T17:15:26Z https://www.soliforum.com/post/42212/#p42212 <![CDATA[Problems loading Solidoodle3 new firmware]]> Purchased a used solidoodle3 off eBay serial number 4926. I don't know age.

Works well except pid is not stable, bad enough to halt print. I know this was a problem in early Marlins. I have a lot of experience with a Prusa and Ramps and changing firmware. Found latest Marlin for Solidoodle and compiled and attempted to upload.  No joy.

Tried:
- set board config in Arduino 1.0.5 to "Sanguino W/ ATmega1284p 16mhz"
- pushing reset before/after starting compile... using different delays. Many times.
- Tried changing Arduino board.text baud rate from 57600 to 38400

Keep getting:
avrdude: stk500_getsync(): not in sync: resp=0x00

Questions:
1. Is there a way to set board to auto reset? Don't need stand alone mode.
2. Do you think reloading printboard boot files would help?
3. Did I select the right board in Arduino?
3. Should I chuck the printboard and switch to Ramps?

Any suggestions would be appreciated.

]]> https://www.soliforum.com/user/4128/ 2013-11-22T15:57:11Z https://www.soliforum.com/post/42198/#p42198