2013-11-09T00:42:05Z PunBB https://www.soliforum.com/topic/4487/massive-oozing/ Sounds like filament contaminant.... moisture?

]]> https://www.soliforum.com/user/296/ 2013-11-09T00:42:05Z https://www.soliforum.com/post/41100/#p41100 Yea, extruder turns off. I'm only concerned because it never used to do that. It kind of seems like the longer a print goes now, the oozier it gets. For example, 30 minutes into a print there are more blobs and strings than earlier. Again, never really happened like that before. Was usually much more consistent through the whole print.

]]> https://www.soliforum.com/user/3491/ 2013-11-09T00:01:54Z https://www.soliforum.com/post/41096/#p41096 Do you have it set to turn off the extruder heat off/down after the print completes? If so then maybe add a some post print gcode to retract and relieve the back pressure. For the most part I never complain about free flowing filament, considering the alternative.

]]> https://www.soliforum.com/user/3054/ 2013-11-08T23:47:00Z https://www.soliforum.com/post/41094/#p41094 Dunno what's happening, but lately it seems like the SD has been oozing a lot more than usual. For example, in the picture below this is how much oozes out after a print completes. It's never been that long before. At most in the past it's just been a little curl that might come out 1/4 of an inch. I'm even down to printing at 180 degrees for ABS. Maybe the consistency of this Sainsmart roll is changing? or anyone else have any thoughts?

]]> https://www.soliforum.com/user/3491/ 2013-11-08T04:40:41Z https://www.soliforum.com/post/40997/#p40997