<![CDATA[SoliForum - 3D Printing Community — Coarse lines upon print]]> 2013-10-22T14:14:46Z PunBB https://www.soliforum.com/topic/4307/coarse-lines-upon-print/ <![CDATA[Re: Coarse lines upon print]]> RavensCrest wrote:

used to use microwaved rice in ziplock bag... but it melts thru.. lol rice heats up soo fast.

+1

]]> https://www.soliforum.com/user/1906/ 2013-10-22T14:14:46Z https://www.soliforum.com/post/39621/#p39621 <![CDATA[Re: Coarse lines upon print]]> used to use microwaved rice in ziplock bag... but it melts thru.. lol rice heats up soo fast.

]]> https://www.soliforum.com/user/651/ 2013-10-21T23:45:41Z https://www.soliforum.com/post/39568/#p39568 <![CDATA[Re: Coarse lines upon print]]> Everything is all fixed. Turns out the thumb screw wasn't tightened enough.

]]> https://www.soliforum.com/user/3753/ 2013-10-21T02:01:24Z https://www.soliforum.com/post/39462/#p39462 <![CDATA[Re: Coarse lines upon print]]> Looks like bad adhesion because the filament was not hot enough. Raise temperature for that filamment 5 degrees at a time to see if that helps.

]]> https://www.soliforum.com/user/2747/ 2013-10-21T01:46:06Z https://www.soliforum.com/post/39460/#p39460 <![CDATA[Re: Coarse lines upon print]]> What is blurry photo supposed to be?

I am far more uncertain of what you're trying to show.

Can you let us know what it is that went wrong? I just see a build platform with some plastic crud stuck to it.

IS this after you removed a part? before you started printing? After a few minutes of printing?


Can you extrude correctly in the air? (manually extruding)

]]> https://www.soliforum.com/user/192/ 2013-10-21T01:42:48Z https://www.soliforum.com/post/39459/#p39459 <![CDATA[Coarse lines upon print]]> Hello!

Recently, I've been printing with red ABS, and I got this coarse result as seen in the attached image.

I'm not exactly sure what is going on here. What do I have to do to fix it?

]]> https://www.soliforum.com/user/3753/ 2013-10-21T01:32:25Z https://www.soliforum.com/post/39458/#p39458