Not without the desktop software .

But it may have been a 1-time deal. I was adding supports to a complicated STL, so it may be that in other circumstances the supports don't cause mesh problems. And, for what it's worth, I could still slice the "incomplete mesh" version without problem.

I just wana know how to use support and/or rafting with the slicer that comes with the SD3.

does anyone know how to do that?

But it may have been a 1-time deal. I was adding supports to a complicated STL, so it may be that in other circumstances the supports don't cause mesh problems. And, for what it's worth, I could still slice the "incomplete mesh" version without problem.

upload part. they will email you a link to download once its done.

Recently I learned how to make support material with meshmaker 2.0 . very nice supports, took me about an hour to figure out how to move in the program, and another hour to get comfortable with the support generator. Had to run final STL through cloud.netfabb.

Use tutorials on youtube

how do I run parts through net fab once I have it?

Use tutorials on youtube

because I tried using Skeinforge activated rafting and support and it wont print it with either setting.

any advise is helpful.

I have read the wiki, and I must be missing some really small detail for these settings to actually print

I have the SD3 heated bed, the works.

thankyou,
Ryan.