<![CDATA[SoliForum - 3D Printing Community — Small pile of pellets on motor side.. v1.1?]]> 2013-10-13T21:41:53Z PunBB https://www.soliforum.com/topic/4222/small-pile-of-pellets-on-motor-side-v11/ <![CDATA[Re: Small pile of pellets on motor side.. v1.1?]]> Yeah, it has to do with the position of the auger relative to the barrel. I think I'll refine it in the next revision, but I've held it constant for now until I have time to test 'n tune.

]]> https://www.soliforum.com/user/221/ 2013-10-13T21:41:53Z https://www.soliforum.com/post/38833/#p38833 <![CDATA[Re: Small pile of pellets on motor side.. v1.1?]]> elmoret wrote:

Yup, normal. That's a little more than I see but not too extreme.

Ok cool!  Yeah no biggie it might have been longer than 20 hours as well. 

Quick reply!

Thanks,

Ben

]]> https://www.soliforum.com/user/625/ 2013-10-13T17:13:53Z https://www.soliforum.com/post/38818/#p38818 <![CDATA[Re: Small pile of pellets on motor side.. v1.1?]]> Yup, normal. That's a little more than I see but not too extreme.

]]> https://www.soliforum.com/user/221/ 2013-10-13T17:06:06Z https://www.soliforum.com/post/38816/#p38816 <![CDATA[Small pile of pellets on motor side.. v1.1?]]> Hey,

v1.1 - Serial 380

I've assembled and I've extruded 2lbs of ABS

After running the last 3 days for a total of about 20 hours there's a small pile of pellets (IMG_8077.jpg) below where the auger enters the wooden block.  Is this normal?

The nipple was 100% clean, all lips removed.  But I guess the odd pellet makes it in reverse?

I've also created a new object on Thingiverse for my re-designed Electronics Enclosure and Hopper.
http://www.thingiverse.com/thing:165190

Thanks in advance,

Ben

]]> https://www.soliforum.com/user/625/ 2013-10-13T16:51:46Z https://www.soliforum.com/post/38814/#p38814