<![CDATA[SoliForum - 3D Printing Community — Solidoodle Nozzle question]]>2013-10-10T22:36:18ZPunBBhttps://www.soliforum.com/topic/4198/solidoodle-nozzle-question/<![CDATA[Re: Solidoodle Nozzle question]]>Thanks Ian!]]>https://www.soliforum.com/user/2861/2013-10-10T22:36:18Zhttps://www.soliforum.com/post/38632/#p38632<![CDATA[Re: Solidoodle Nozzle question]]>The nozzles at Makergear.com are compatible, and they have a .5. http://www.makergear.com/products/nozzles]]>https://www.soliforum.com/user/14/2013-10-10T22:33:41Zhttps://www.soliforum.com/post/38631/#p38631<![CDATA[Re: Solidoodle Nozzle question]]>Do you offer nozzles in larger bores than .40mm ? On your site I could only see one size listed. I'd probably be willing to buy a complete hot-end if I could get a different nozzle on it.]]>https://www.soliforum.com/user/2861/2013-10-10T21:54:38Zhttps://www.soliforum.com/post/38629/#p38629<![CDATA[Re: Solidoodle Nozzle question]]>You'll have to redo some slic3r settings at the very least. Can't say I've tried a replicator nozzle myself. It may not be compatible with the threading of our brass barrel.]]>https://www.soliforum.com/user/7/2013-10-10T21:51:34Zhttps://www.soliforum.com/post/38628/#p38628<![CDATA[Solidoodle Nozzle question]]>I've been offered a nozzle with a larger bore, but it's from a Replicator 2 I believe. Is the nozzle interchangeable/compatible?
The wiki makes it look a bit of a pain to swap over? Thoughts on this?
The reason I'm doing it to enable less clog prone printing of filaments such as Laywood.