<![CDATA[SoliForum - 3D Printing Community — sd3 dead]]> 2013-10-09T13:01:00Z PunBB https://www.soliforum.com/topic/4183/sd3-dead/ <![CDATA[Re: sd3 dead]]> i have try your solution but if i cut more i cute on two part the divice xD

for this i can moove the bag of the motor, and i can solve this but my big problem is the reset of my motherboard and de x and y axe wish cannot work correctly  and when i up a stl on repetier the g code is affraid manni picture many symbole

]]> https://www.soliforum.com/user/2950/ 2013-10-09T13:01:00Z https://www.soliforum.com/post/38492/#p38492 <![CDATA[Re: sd3 dead]]> Mine also doesn't line up very well, and for the same reason, but it's not so far out that the filament won't feed; I just have to guide it in with a pair of needle-nose pliers when I'm initially loading filament.

If it's even farther out than that, probably the only thing you can do is remove the E3D from the MK4, then use a modeling knife and files, sandpaper, or even a Dremel moto-tool, to trim back the MK4 around the place the E3D mounts in it, to make the gap large enough to accommodate the E3D.  Naturally you'll want to remove that piece from the extruder head before you do that.

]]> https://www.soliforum.com/user/1356/ 2013-10-09T12:36:10Z https://www.soliforum.com/post/38491/#p38491 <![CDATA[sd3 dead]]> hello i'm a french peaple and i speak very litle english sorry if i offence you when i speak.

i have a very big problem

my hot hend is broken i have buy an another this for the direct extrude  http://e3d-online.com/index.php?route=p … uct_id=52.

i have mount a head mk4 by lawsy (thz lawsy) but new problem, i think about the mk4, he is printed too small and the dissipator don't go inside the mk4 correctly.

i have try to modify the mk4 with a lime but this is not the good solution for having a good alignement with the axe of the fillament.

again a problem i have push the button reset of the mother board because i have see when i have mount the complet head on the sd3 the divece work not correctly.

imagine the head in the media plate

when i push on repetier the arrow to left the chario go to the left and i have a vis who hit  switch.

after every work not. shut down of sd3 by the power.
i move with my hand the chario on the right gently.
power on i re launch repetier and now i click on the arrow tho the right and surprise 2 solution:

the first the chario it the axis  Y and the motor not love that (brrrrrrrrr)

or  2 solution the chariot stop move on a place difine when you pusk the stop switch.

i'm very lost with my machine can you help me ?

]]> https://www.soliforum.com/user/2950/ 2013-10-09T11:09:18Z https://www.soliforum.com/post/38484/#p38484