<![CDATA[SoliForum - 3D Printing Community — can printing sequence be controlled when printing multiple copies?]]> 2013-09-30T17:50:02Z PunBB https://www.soliforum.com/topic/4052/can-printing-sequence-be-controlled-when-printing-multiple-copies/ <![CDATA[Re: can printing sequence be controlled when printing multiple copies?]]> You could try Cura.
Cura can print each part completely before moving to the next.  The major caveat is that to individually print closely spaced parts, the parts cannot be taller than the distance from the extruder tip to the 8mm  X-axis rods the extruder runs on, or spaced any closer than the external dimensions of the extruder.  All this is entered into Cura as a setup.  It all works pretty seamlessly.

Also, Cura output seems to be more efficient in general compared to Slic3r, which is not a very high bar in my experience.

Additionally, I have found that you can help mitigate the strangeness of Slic3r output by changing the dimensions of the model slightly to make wall thicknesses an even multiple of the extruded filament width. And also adjusting the number perimeters as well.  Cylindrical parts can be infilled concentrically.  All this in an effort to make as many continuous extruder runs as possible before the slicer deems it necessary to change tactics.

You don't have to do the math here, if you do not want to.  Slice the part and look at the layers.  Make adjustments, to the model within design constraints or to the Slic3r configuration, where the pattern gets weird.

Hope this helps.

]]> https://www.soliforum.com/user/2632/ 2013-09-30T17:50:02Z https://www.soliforum.com/post/37732/#p37732 <![CDATA[Re: can printing sequence be controlled when printing multiple copies?]]> I think Slic3r is pretty bad at route optimization. I get random illogical movements all the time.  I would like to hear if anyone else chimes in with more useful advice.

]]> https://www.soliforum.com/user/192/ 2013-09-27T01:02:16Z https://www.soliforum.com/post/37422/#p37422 <![CDATA[can printing sequence be controlled when printing multiple copies?]]> I'm printing multiple copies of the same stl and slic3r is not taking the best route when moving from one copy to the next.  Can that be controlled somehow so I can set what order i want to print?

]]> https://www.soliforum.com/user/2628/ 2013-09-26T19:53:30Z https://www.soliforum.com/post/37400/#p37400