<![CDATA[SoliForum - 3D Printing Community — After very first print, extruder not heating up anymore ?]]> 2012-11-02T22:10:20Z PunBB https://www.soliforum.com/topic/399/after-very-first-print-extruder-not-heating-up-anymore/ <![CDATA[Re: After very first print, extruder not heating up anymore ?]]> Well its been a week, and with Sandy on top of things, I don't think my new hot end has been shipped...
I though waiting for the printer was bad...
Having one sitting idle on my desk is worse...

]]> https://www.soliforum.com/user/245/ 2012-11-02T22:10:20Z https://www.soliforum.com/post/3977/#p3977 <![CDATA[Re: After very first print, extruder not heating up anymore ?]]> jul654321 wrote:

Yeah I guess I will do that, this time it happened mid print, I appreciate the fact that there is a check before trying to extrude through a cool extruder...

I guess I will get a new one on the way...

Thanks for the help.

It saves a lot of damage.

]]> https://www.soliforum.com/user/7/ 2012-11-01T19:23:58Z https://www.soliforum.com/post/3851/#p3851 <![CDATA[Re: After very first print, extruder not heating up anymore ?]]> Yeah I guess I will do that, this time it happened mid print, I appreciate the fact that there is a check before trying to extrude through a cool extruder...

I guess I will get a new one on the way...

Thanks for the help.

]]> https://www.soliforum.com/user/245/ 2012-10-28T02:06:33Z https://www.soliforum.com/post/3494/#p3494 <![CDATA[Re: After very first print, extruder not heating up anymore ?]]> Tape it down, and ask Solidoodle for a new one.  Might as well have a new one on the way in case the connection breaks completely.

]]> https://www.soliforum.com/user/14/ 2012-10-27T20:14:54Z https://www.soliforum.com/post/3472/#p3472 <![CDATA[Re: After very first print, extruder not heating up anymore ?]]> So I jiggled the connector with the green wires, and it seems to have done the trick, now I'm just worried that it would get cold mid-print, I will keep an eye on it.

]]> https://www.soliforum.com/user/245/ 2012-10-27T19:49:32Z https://www.soliforum.com/post/3471/#p3471 <![CDATA[Re: After very first print, extruder not heating up anymore ?]]> Well this sucks.
There is voltage at the heater core, so I'm guessing the heater is just done...
After a 9 minutes print sad

]]> https://www.soliforum.com/user/245/ 2012-10-27T19:09:24Z https://www.soliforum.com/post/3470/#p3470 <![CDATA[After very first print, extruder not heating up anymore ?]]> As the title says, after my very first print, I lowered the temp of the extruder to 80 while skeinforge was finishing slicing my next attempt...

When I turned it back up to 200, it kept going down, and now it just won't go up.

Where do I start ?
I tried resetting the printer and just unplugging it, letting it cool and starting again, same result.

First print was fantastic, I just want to keep going !

Thanks for the help

]]> https://www.soliforum.com/user/245/ 2012-10-27T18:32:22Z https://www.soliforum.com/post/3469/#p3469