<![CDATA[SoliForum - 3D Printing Community — Nylon 645 Issue]]> 2013-10-02T16:42:22Z PunBB https://www.soliforum.com/topic/3901/nylon-645-issue/ <![CDATA[Re: Nylon 645 Issue]]> Slow down. I found that with nylon and tglase I am running almost half speed or i get jams like that.

]]> https://www.soliforum.com/user/1682/ 2013-10-02T16:42:22Z https://www.soliforum.com/post/37917/#p37917 <![CDATA[Re: Nylon 645 Issue]]> have you tried lowering the extrusion acceleration speed for the stepper?

]]> https://www.soliforum.com/user/296/ 2013-09-13T04:26:48Z https://www.soliforum.com/post/36172/#p36172 <![CDATA[Re: Nylon 645 Issue]]> I wonder if someone could do a mod with brass tube cut like a /\ to fit right near the cog and bearing, to prevent that.

]]> https://www.soliforum.com/user/2694/ 2013-09-12T23:49:09Z https://www.soliforum.com/post/36138/#p36138 <![CDATA[Nylon 645 Issue]]> Any suggestions on this jamming issue with Nylon 645? I had a similar issue with T-Glass in the beginning, but that was due to irregular shape. This 645 is a bit oval shaped, but nothing compared to section of T-Glass I had an issue with.

I've tried adjusting the layer height, extrusion width, print temperature, platform height, and print speed with no luck. I am able to feed through filament manually without an issue. I fed 100mm through while checking extruder multiplier without a problem. I have an E3D hotend so I don't suspect the filament is warming, but 645 filament is quite flexible.

Any suggestions?  neutral

http://i.imgur.com/oHryXqp.jpg

]]> https://www.soliforum.com/user/1016/ 2013-09-12T21:48:47Z https://www.soliforum.com/post/36122/#p36122