SoliForum - 3D Printing Community — Slic3r Questions: Solid Infill

Re: Slic3r Questions: Solid Infill

2013-09-16T01:14:07Z

Thanks IanJohnson. You guys are the best. I managed to fix it thanks

Re: Slic3r Questions: Solid Infill

2013-09-12T23:41:39Z

Does the width of the wall divide evenly into 4 perimeters at your extrusion width? It looks like once the perimeters are in, it is too wide to be filled by one thread, but too narrow to be filled by 2 so it does the best it can with a fill pattern. You can try reducing the extrusion width to a number that is closer to dividing evenly by the wall thickness, but don't go smaller than the size of your nozzle. Or make the wall a little thicker and set to 2 perimeters so once it has done 2 outer and 2 inner the wall is solid.

Re: Slic3r Questions: Solid Infill

2013-09-12T23:08:42Z

Tried that as well, didn't change a thing

Re: Slic3r Questions: Solid Infill

2013-09-12T22:26:11Z

Does setting the "make every 1 infill layer solid" option work?

Re: Slic3r Questions: Solid Infill

2013-09-12T21:42:14Z

oh and I tried what Tomek posted a couple days ago about using an outrageous number but still nothing.

Thanks Guys

Slic3r Questions: Solid Infill

2013-09-12T21:38:17Z

Hey Guys,

So I did some searching but I can't find any solution to the problem. Im printing, what I call a cap, upside down. The Walls of the cap are not filling completely/ at all and its always starting and stoping at the same point even though randomize starting points is on. I've tried infill at .99 and 1 but still get the same result as if it was .2.

Here are screen shots of the vizualized g code and some others.