SoliForum - 3D Printing Community — I'm down, can't work, pls help. Arduino/Printrboard update probs

Re: I'm down, can't work, pls help. Arduino/Printrboard update probs

2013-09-11T22:35:08Z

Okay guys, I did what Jason said, and posted the config files in the other thread: http://www.soliforum.com/topic/3864/que … all-stuck/

I AM SORRY to be such a bleeding pain in the @$$ but I don't know the perimeters the config files need. If you can edit the info PLEASE I will not only use it to get my machine running, I will include it in the tutorial I hope to compile after its all over.

Needless to say, your time and expertise are much appreciated.

Re: I'm down, can't work, pls help. Arduino/Printrboard update probs

2013-09-11T19:51:01Z

I posted a reply on your original thread with the answer to your question, I ran into this exact problem

Re: I'm down, can't work, pls help. Arduino/Printrboard update probs

2013-09-11T19:47:44Z

I seem to recall seeing a note somewhere that said everything now builds with arduino 1.0 or 1.05 or something like that. Perhaps 022 is now too old? (Can't find the link where I read this anymore, so take it with a grain of salt).

Re: I'm down, can't work, pls help. Arduino/Printrboard update probs

2013-09-11T19:14:45Z

Can you jump on the IRC?

http://webchat.freenode.net/?channels=s … amp;uio=d4

I'm down, can't work, pls help. Arduino/Printrboard update probs

2013-09-11T19:00:51Z

I'm starting a new thread because the last thread ran out of gas. I've been unable to work for the last few days and really need to get this finished.

I've physically installed a new E3D head on my SD3 and am, I think, almost finished. I'm stuck trying to update the Marlin firmware on my SD-version Printrboard. Here's where I'm at:

I went ahead with the instructions to compile the firmware. It said "compiling..." then burped. This is the error:
1286\cores\at90usb1286/main.cpp:6: undefined reference to `setup'
C:\Users\Kent\Downloads\arduino0022\arduino-0022\hardware\at90usb1286\cores\at90usb1286/main.cpp:8: undefined reference to `loop'

Now what, please? That path and file DO exist on my computer. I have anti-virus, malware, SONAR, etc. turned off. I am connected to, and plugged into, the printer and the green LED is on.

I went to the Arduino forum and asked and here's what the guys said, I don't speak Arduino, so I am really lost now:

http://forum.arduino.cc/index.php?topic=187335.0

Please help this wandering soul get his machine compiled and running again. I appreciate your time and help.