<![CDATA[SoliForum - 3D Printing Community — can someone explain this slice?]]> 2013-09-01T16:30:25Z PunBB https://www.soliforum.com/topic/3754/can-someone-explain-this-slice/ <![CDATA[Re: can someone explain this slice?]]> 2n2r5 wrote:

That gap isn't big enough for slicer to fit another pass. If you back off your perimeters to 2 the infill should take over and fill that gap for you.

that did it.  had my parameters set to 4 from another print.  I was able to get it to fill in at 3.  Thanks!

]]> https://www.soliforum.com/user/2628/ 2013-09-01T16:30:25Z https://www.soliforum.com/post/34873/#p34873 <![CDATA[Re: can someone explain this slice?]]> That gap isn't big enough for slicer to fit another pass. If you back off your perimeters to 2 the infill should take over and fill that gap for you.

]]> https://www.soliforum.com/user/1906/ 2013-09-01T16:21:16Z https://www.soliforum.com/post/34871/#p34871 <![CDATA[can someone explain this slice?]]> I just upgraded to the new RH and was checking the settings so i did a slice of a part i have already printed.  It could have been the other version of slic3r did the same thing i just didn't notice it.  Anyway, could someone explain why the top and bottom layers are not creating a bottom/top in the area around the radius?

]]> https://www.soliforum.com/user/2628/ 2013-09-01T16:02:57Z https://www.soliforum.com/post/34870/#p34870