SoliForum - 3D Printing Community — L_HEATERS_ON_QUEST

Re: L_HEATERS_ON_QUEST

2013-09-01T17:42:39Z

Thank you. Apparently there was a loose connection somewhere.

Re: L_HEATERS_ON_QUEST

2013-09-01T16:01:11Z

I had the same thing happen because the USB cable came unplugged (D^%^%$^ dog got tangled in the cord under the desk)
I had to turn the power off at the wall wart and start over.

Re: L_HEATERS_ON_QUEST

2013-09-01T15:42:27Z

I am just a few seconds into the print when the error pops up. If I clear and kill the job, then try to disconnect with the heater still on, I get the message again. I'll double check all my connections and try again.

Re: L_HEATERS_ON_QUEST

2013-08-30T23:24:58Z

Usually a popup box with the heater message appears when you disconnect from the print (and the heaters are still on).

When and where are you getting the error message?

Re: L_HEATERS_ON_QUEST

2013-08-30T16:26:10Z

In addition - It doesn't matter whether I click Yes, No, or Cancel. After the error goes away I can't do anything with the printer until I disconnect and reconnect.

L_HEATERS_ON_QUEST

2013-08-30T16:25:01Z

I had some issues with end stops on my Solidoodle 3, so I followed the instructions for making a perfect circle and recalibrated the machine. I also uninstalled and reinstalled the latest version of the software. I made a couple more prints and now I get an error from Repetier: L_HEATERS_ON_QUEST

All I can find by searching is that the error means -
id="L_HEATERS_ON_QUEST" ver="8">Some heaters are still on. Shall I disable them?

Does anyone know why I would receive this error, or how to avoid it?