<![CDATA[SoliForum - 3D Printing Community — protocol to extrude PLA]]> 2013-08-20T14:38:46Z PunBB https://www.soliforum.com/topic/3615/protocol-to-extrude-pla/ <![CDATA[Re: protocol to extrude PLA]]> Just a little further down the forum:

http://www.soliforum.com/topic/2847/tem … -filament/

Most important: predrying.

]]> https://www.soliforum.com/user/221/ 2013-08-20T14:38:46Z https://www.soliforum.com/post/33650/#p33650 <![CDATA[protocol to extrude PLA]]> Hi,

I can't find any subject on this but if there exists one then sorry in advance.

We are doing project to print larger objects in several batches and the filastruder would greatly decrease the cost.

however, It seems that extruding PLA is tricker than extruding ABS. Does anyone on the forum experimented with PLA and have they found a workflow that works. the printing will be done on an Ultimaker.

Thanks in advance and if there is already a thread about this subject then please link it through.

thanks again,

bye

]]> https://www.soliforum.com/user/3098/ 2013-08-20T09:44:40Z https://www.soliforum.com/post/33629/#p33629