<![CDATA[SoliForum - 3D Printing Community — calibrate solidoodle 2]]> 2013-08-19T05:10:24Z PunBB https://www.soliforum.com/topic/3577/calibrate-solidoodle-2/ <![CDATA[Re: calibrate solidoodle 2]]> iowajames wrote:

This should be moved to Help/Repair/Maintenance.

+1

]]> https://www.soliforum.com/user/55/ 2013-08-19T05:10:24Z https://www.soliforum.com/post/33488/#p33488 <![CDATA[Re: calibrate solidoodle 2]]> This should be moved to Help/Repair/Maintenance.

]]> https://www.soliforum.com/user/717/ 2013-08-18T14:10:08Z https://www.soliforum.com/post/33419/#p33419 <![CDATA[Re: calibrate solidoodle 2]]> thank you i will try that

]]> https://www.soliforum.com/user/3012/ 2013-08-17T03:48:03Z https://www.soliforum.com/post/33276/#p33276 <![CDATA[Re: calibrate solidoodle 2]]> tapoutms wrote:

question i change the brass barrel of my solidoodle 2 now the heat bed hit the Extruder Hot End  how i can calibrate it please help and where i can buy a big  roll of Kapton Tape for the heat bed.

Hi tapout

If you look near the back of the printer, to the left of the Z-axis support rods, there's a little black screw attached to a piece of plastic mounted on the back wall of the printer. That is your Z-stop. If you want your bed to stop sooner, you need to lower that screw so it hits the button (you'll notice this button when you press Z-home) sooner.


That said, make sure you tightened the brass barrel well. It sounds like you may not have, if your assembly is now much lower.

]]> https://www.soliforum.com/user/192/ 2013-08-16T22:42:49Z https://www.soliforum.com/post/33249/#p33249 <![CDATA[calibrate solidoodle 2]]> question i change the brass barrel of my solidoodle 2 now the heat bed hit the Extruder Hot End  how i can calibrate it please help and where i can buy a big  roll of Kapton Tape for the heat bed.

]]> https://www.soliforum.com/user/3012/ 2013-08-16T21:02:46Z https://www.soliforum.com/post/33242/#p33242