<![CDATA[SoliForum - 3D Printing Community — Ben Franklin bust]]> 2013-11-05T08:13:01Z PunBB https://www.soliforum.com/topic/3552/ben-franklin-bust/ <![CDATA[Re: Ben Franklin bust]]> +1 for the presto parts finisher!

]]> https://www.soliforum.com/user/2252/ 2013-11-05T08:13:01Z https://www.soliforum.com/post/40757/#p40757 <![CDATA[Re: Ben Franklin bust]]> Can you purge them in water to stop the acetone from eating the plastic between exposures?

]]> https://www.soliforum.com/user/3724/ 2013-11-04T08:45:00Z https://www.soliforum.com/post/40668/#p40668 <![CDATA[Re: Ben Franklin bust]]> I've seen Ian's method.  It is on my list of things to get.  Just wanted to see if you were doing something similar, or using a different method.  Your print came out awesome.

]]> https://www.soliforum.com/user/777/ 2013-08-15T14:53:12Z https://www.soliforum.com/post/33068/#p33068 <![CDATA[Re: Ben Franklin bust]]> Thanks,I use a Presto Kitchen Kettle 

http://www.amazon.com/Presto-06006-Kitc … hen+kettle

I learned about it from Ian's blog: http://solidoodletips.wordpress.com/201 … -finisher/

At .1mm there was very little layering,it only took 20secs in the vapor bath to get that result.You can get close to the same at .3 layers but it's best to do multiple exposures at 20-30 sec at a time.

]]> https://www.soliforum.com/user/2441/ 2013-08-14T22:31:01Z https://www.soliforum.com/post/32973/#p32973 <![CDATA[Re: Ben Franklin bust]]> Looks awesome.  Couldn't see any layering in that photo.  Very professional results.  What equipment are you using for your vapor bath?

]]> https://www.soliforum.com/user/777/ 2013-08-14T20:39:48Z https://www.soliforum.com/post/32957/#p32957 <![CDATA[Ben Franklin bust]]> Sd2 at .1mm
Acetone vapor bath
Finished with Rustoleum "Oil Rubbed Bronze" spray  paint.

]]> https://www.soliforum.com/user/2441/ 2013-08-14T19:51:59Z https://www.soliforum.com/post/32951/#p32951