SoliForum - 3D Printing Community — Help! My solidoodle 3 thinks its a soliddodle 2.

Re: Help! My solidoodle 3 thinks its a soliddodle 2.

2014-01-03T02:09:08Z

when installing software make sure to select which printer 2 or 3 is being used. then go into printer settings and make sure bed dimensions etc are correct for your printer as this is what tells it who it is so to speak. default often is set at SD1 size which is smaller yet I found when updating software.

Re: Help! My solidoodle 3 thinks its a soliddodle 2.

2013-07-29T14:08:27Z

3DGravey wrote:

Posting again hoping someone has a clue what's going on with my printer.
Problem: Every print I start, is off from center by 40mm to the right, and nearly as much to the
Back. No matter what I do in RH and Slic3r the center is off on every print.
I posted last week under "bed size calibration problem". Not much luck with any help. I'm still optimistic someone knows how to fix this.
Thanks again everyone!

Please do not double post. Also, these posts go in the help/repair section. Someone will answer you original post as soon as possible. Also, make sure to e-mail support@solidoodle.com

Help! My solidoodle 3 thinks its a soliddodle 2.

2013-07-29T13:22:36Z

Posting again hoping someone has a clue what's going on with my printer.

Problem: Every print I start, is off from center by 40mm to the right, and nearly as much to the
Back. No matter what I do in RH and Slic3r the center is off on every print.

I posted last week under "bed size calibration problem". Not much luck with any help. I'm still optimistic someone knows how to fix this.

Thanks again everyone!