<![CDATA[SoliForum - 3D Printing Community — Bumping Noise]]> 2013-07-31T13:33:24Z PunBB https://www.soliforum.com/topic/3314/bumping-noise/ <![CDATA[Re: Bumping Noise]]> twoseams wrote:

Calibrating the belts worked. Just took a couple of tries.  Thanks for the help.

No problem. Marking as resolved.

]]> https://www.soliforum.com/user/7/ 2013-07-31T13:33:24Z https://www.soliforum.com/post/31510/#p31510 <![CDATA[Re: Bumping Noise]]> Calibrating the belts worked. Just took a couple of tries.  Thanks for the help.

]]> https://www.soliforum.com/user/2737/ 2013-07-31T06:36:57Z https://www.soliforum.com/post/31488/#p31488 <![CDATA[Re: Bumping Noise]]> Put some lithium grease on the rods. That fixed my "bumping".

]]> https://www.soliforum.com/user/2851/ 2013-07-28T02:57:47Z https://www.soliforum.com/post/31183/#p31183 <![CDATA[Re: Bumping Noise]]> Can you take a pic of the print where the noise starts? if you are overextruding the printhead can start bumping over the previous layer and make noise this can also cause lost steps if there is a lot of overextruding going on.

just mess up the link a little(you tube dot com/123456) so we can still figure it out once you have 10 posts you can post links and pics normally

]]> https://www.soliforum.com/user/296/ 2013-07-25T22:37:02Z https://www.soliforum.com/post/31000/#p31000 <![CDATA[Re: Bumping Noise]]> Have you calibrated your belts? This may help: http://wiki.solidoodle.com/belt-adjustment

]]> https://www.soliforum.com/user/7/ 2013-07-25T20:41:42Z https://www.soliforum.com/post/30980/#p30980 <![CDATA[Bumping Noise]]> Hello,
I've been trying to get my new Solidoodle 3 printer working for about a week now and just can't crack it.  When moving in the negative y direction (towards the leds) it starts to make this bumping noise.  This causes the print to get all wavy which I believe throws the print off.  This can lead to the printer losing its position on the same layer or shifting the print after going up a layer.

I have a video but it won't let me post the link

Has anyone experienced something like this before, any ideas?

]]> https://www.soliforum.com/user/2737/ 2013-07-25T18:49:11Z https://www.soliforum.com/post/30968/#p30968