SoliForum - 3D Printing Community — Warping on large print

Re: Warping on large print

2013-07-07T21:24:21Z

My 2c: when I first got printer, I quickly switched to a glass plate (just went to picture frame shop and asked them to cut; nothing fancy, just plain glass, clipped on just 2 corners to allow for some expansion). That works wonders (using it with hairspray at 100C for ABS, and without at 70C for PLA). Next thing that made a big difference for me was bed leveling and adjustment. For ABS, I go significantly closer that the Solidoodle wiki suggests; with ABS not a problem, with PLA might clog nozzle. Worth trying a, say, 1/6 turn on your z endstop screw. Finally, couple of days ago I built an enclosure (after covering printer with a blanket propped up on an overturned stool convinced me that its really worth it) and, with that, even the trickiest prints (before) are routine (eg an iPhone case I designed, which long and thin, filling the entire diagonal, was almost impossible to print before, but now it's easy). Good luck!

Re: Warping on large print

2013-07-07T18:30:58Z

mconsidine wrote:

No problem - I'll have to look up the "pad" technique. How big a "footprint" are you trying to print?
EDIT : okay, just looked that up. Have you tried putting a 3-6mm "brim" or "skirt" around your object?

That's quite a box (3x10x10 cm) -> i've posted it in attachment

No, i've only tried a raft! and pads (1cm circle at each corner)

I will try it.

Re: Warping on large print

2013-07-07T17:51:44Z

No problem - I'll have to look up the "pad" technique. How big a "footprint" are you trying to print?

EDIT : okay, just looked that up. Have you tried putting a 3-6mm "brim" or "skirt" around your object?

Re: Warping on large print

2013-07-07T17:34:41Z

Hi, you are right, i've corrected "wrapping", sorry, english isn't my language.
By pad, it's a strategy i've read on ic3dprinters (section " Combat Warping with Pads "), but it doesn't work.

i've tried to pause the print to add clothespin on the pads, to avoid warping. (too late).

I cant enclose more the SD (it was totally closed) and that's still warping (on large print)...

Re: Warping on large print

2013-07-07T16:48:29Z

I am guessing you mean "warping" which is coming about from layers of ABS cooling at different rates. Not sure what you mean by the pad and clothespin. But if you are trying to enclose the SD then that is the right direction to go.

Warping on large print

2013-07-07T16:43:25Z

Hi, i've just bought an SD2.
I've made few tries, but i've get warping issue on large box.

I've tried to clean klape with acetone, tried to get the SD more isolated, tried different temperature printbed (from 60 to 110).
But i've still get warping with 0.3 print after 50-60 layers (sometimes it happen later). Tried with different resolution (from 0.1 to 0.4, tried also to play with first layer speed)... (i've already set the Z axis)

Hard to find a good configuration.

I'm actually trying adding pad on my stl, but after few layers, two of the pad started warping .
I tried to add clothespin on the pad (the main structure -> a box) isn't warped yet.

Is there a way to stop warping with ABS on large print?