SoliForum - 3D Printing Community — Custom Start G Code?

Re: Custom Start G Code?

2013-07-01T23:49:02Z

ooh ok thanks I was looking for a box at the bottom labeled SAVE for dummies like me....

Re: Custom Start G Code?

2013-07-01T23:41:24Z

Not my pic so ignore the blue box.

Save icon can be seen at the top left, immediately to the right of '- Default -'.

Re: Custom Start G Code?

2013-07-01T23:10:41Z

now im having a problem editing the G code. im using the repetier host slicer app and when your in the configure part where you change the infill and perimeters, theres no option to SAVE the stuff you change?

Re: Custom Start G Code?

2013-07-01T21:34:39Z

Also in Slic3r, there is a little disk icon for save. Click it and a box will appear with a name. Change the name to save a new profile or keep the same name to update the current profile.

Re: Custom Start G Code?

2013-07-01T21:31:54Z

THANKS!

Re: Custom Start G Code?

2013-07-01T21:23:17Z

Anchor here:

http://www.soliforum.com/topic/231/impr … end-gcode/

Custom Start G Code?

2013-07-01T21:14:34Z

so i finaly did my first prints!!! and a few things i notice right off the bat, i need to print an anchor. when it gote to print the skirt it only get half of it. and my cubes arent cubes my X axis is 10mm my my Y is 9.72 and Z is 9.72

also i printed 3 thumb screws that look okay.

and in slicer if you click configure and make changes is there no way to save them?

how the eff do i print and anchor ?

if this post is in the wrong place please move it to where it should go.