<![CDATA[SoliForum - 3D Printing Community — No: 82]]>2013-07-01T06:49:11ZPunBBhttps://www.soliforum.com/topic/3014/no-82/<![CDATA[Re: No: 82]]>AH I see Looks good!]]>https://www.soliforum.com/user/1822/2013-07-01T06:49:11Zhttps://www.soliforum.com/post/28600/#p28600<![CDATA[Re: No: 82]]>They're' feet (3 points creates a plane) it should sit flat on most uneven surfaces.
reesy wrote:
Interesting, is that meant to hang off the end of the table or perhaps be extruding downwards at an angle? I refer to the bulbous part bottom right of the case.
]]>https://www.soliforum.com/user/2521/2013-07-01T05:39:52Zhttps://www.soliforum.com/post/28596/#p28596<![CDATA[Re: No: 82]]>Interesting, is that meant to hang off the end of the table or perhaps be extruding downwards at an angle? I refer to the bulbous part bottom right of the case.]]>https://www.soliforum.com/user/1822/2013-07-01T05:05:27Zhttps://www.soliforum.com/post/28594/#p28594<![CDATA[Re: No: 82]]>The hopper has changed and the fitment is much better (no gap).]]>https://www.soliforum.com/user/2521/2013-07-01T02:53:31Zhttps://www.soliforum.com/post/28572/#p28572<![CDATA[Re: No: 82]]>Aren't the pellets going to spill out the bottom of the hopper? Or is there another part that isn't on there yet?]]>https://www.soliforum.com/user/14/2013-07-01T02:49:11Zhttps://www.soliforum.com/post/28570/#p28570<![CDATA[No: 82]]>Just about ready to extrude.............]]>https://www.soliforum.com/user/2521/2013-07-01T02:17:32Zhttps://www.soliforum.com/post/28567/#p28567
