RavensCrest wrote:

I use RH with slic3r.
@ysb, why is it even an option... sigh...
@Randavian, can you use Kisslicer with repetierHost?

KS is not integrated like Slic3r is.  You run it by itself, save the gcode to your hard drive, then in RH you click load and find that gcode.  Then print. 

KS also slices models quicker than Slic3r.  I would use it for everything, if it had the option to print a brim.

KS is fantastic, I almost predominately use it now.
For support material it comes away easy,  have the gap set to 0.5m.

I'd suggest getting some bike spokes and grinding the end down to form different pick/scraper shapes. I have some I made up years ago for another project. They get into the tight gaps and remove the last bits of fluff that stick. They'll also fit inside holes to remove strings etc.

I use RH with slic3r.
@ysb, why is it even an option... sigh...
@Randavian, can you use Kisslicer with repetierHost?

KS is not integrated like Slic3r is.  You run it by itself, save the gcode to your hard drive, then in RH you click load and find that gcode.  Then print. 

KS also slices models quicker than Slic3r.  I would use it for everything, if it had the option to print a brim.

What slicing program are you using?  I found that when ever I need to do a print with support, I like using Kisslicer instead of Slic3r.  Kisslicer has better settings which will allow you to make supports that will "almost" just snap off. 

If you haven't tried Kisslicer, I would highly recommend do so.  The only draw back to using KS is that it does not have a brim option.  So I still use Slic3r whenever I don't need supports.

edit  :grilled

this is 3rd time I print with support... is there a setting in rapetierHost to make the support easier to pull away? I use honey cone support... and sometimes the wall of the honeycone is imbeded to the model itself, and usually supports are in hard to reach place.. :-( sigh... some body help me!