<![CDATA[SoliForum - 3D Printing Community — Repeteir host eprom settings on mac]]> 2013-12-09T07:28:13Z PunBB https://www.soliforum.com/topic/2850/repeteir-host-eprom-settings-on-mac/ <![CDATA[Re: Repeteir host eprom settings on mac]]> OSX has always had a problem with the eeprom values.

Here is a list of g/m codes ---> http://reprap.org/wiki/G-code

use m92 for setting axe step value ie... 'M92 E xxx'  make sure to use caps wink 'E' is for the extruder stepper/axis

then you can use M500 to save the settings in eeprom
and M501 to read them
and M502 to revert them to factory

]]> https://www.soliforum.com/user/296/ 2013-12-09T07:28:13Z https://www.soliforum.com/post/43671/#p43671 <![CDATA[Re: Repeteir host eprom settings on mac]]> As of 12/2013 you have to enter the G-Code manually in the Print Panel page.

]]> https://www.soliforum.com/user/4217/ 2013-12-09T04:10:57Z https://www.soliforum.com/post/43661/#p43661 <![CDATA[Repeteir host eprom settings on mac]]> I was trying to adjust the flow rate settings but was surprised to see the eprom settings list is empty : /
Any ideas? I checked and I am updated to the latest version of RH and I am running it from my HD (not from a mounted drive)

]]> https://www.soliforum.com/user/1353/ 2013-06-18T02:57:55Z https://www.soliforum.com/post/26770/#p26770