<![CDATA[SoliForum - 3D Printing Community — extruder motor runs only is one direction]]> 2013-06-14T22:28:02Z PunBB https://www.soliforum.com/topic/2805/extruder-motor-runs-only-is-one-direction/ <![CDATA[Re: extruder motor runs only is one direction]]> Another possability is the retraction is causing missed steps from being too fast.  My extruder was not limited on MM/S in the eeprom settings and I was getting missed steps on retraction and prime.

]]> https://www.soliforum.com/user/1290/ 2013-06-14T22:28:02Z https://www.soliforum.com/post/26391/#p26391 <![CDATA[Re: extruder motor runs only is one direction]]> You can confirm by putting a bit of a marker on the Shaft of the extruder.
If it is confirmed you might verify the connectors...

]]> https://www.soliforum.com/user/444/ 2013-06-14T12:48:51Z https://www.soliforum.com/post/26322/#p26322 <![CDATA[extruder motor runs only is one direction]]> My extruder motor seems to run only in one direction... reverse.

I can put my hand on the end of the motor shaft and feel it is not pulling filament into the extruder head.

anyone know what I can do about this.

Thanks.

Homer

]]> https://www.soliforum.com/user/2333/ 2013-06-14T11:16:54Z https://www.soliforum.com/post/26315/#p26315