<![CDATA[SoliForum - 3D Printing Community — Test print of cylinder... What should i configure next?]]> 2013-06-06T02:23:59Z PunBB https://www.soliforum.com/topic/2696/test-print-of-cylinder-what-should-i-configure-next/ <![CDATA[Re: Test print of cylinder... What should i configure next?]]> You could try the nickle calibration to get you x-y dialed in


http://www.thingiverse.com/thing:84795

]]> https://www.soliforum.com/user/1906/ 2013-06-06T02:23:59Z https://www.soliforum.com/post/25413/#p25413 <![CDATA[Re: Test print of cylinder... What should i configure next?]]> It looks good... there's no noticeable z banding (the extreme kind, we all get some lines as this is layering), and the vertical looks straight.  Can't tell about the roundness so I can't comment on the xy aspects.

]]> https://www.soliforum.com/user/129/ 2013-06-05T21:28:13Z https://www.soliforum.com/post/25401/#p25401 <![CDATA[Re: Test print of cylinder... What should i configure next?]]> Opps lol

]]> https://www.soliforum.com/user/1769/ 2013-06-05T21:08:03Z https://www.soliforum.com/post/25396/#p25396 <![CDATA[Re: Test print of cylinder... What should i configure next?]]> Showing not available to look at...

EDIT:
Not shared I guess

]]> https://www.soliforum.com/user/129/ 2013-06-05T20:00:06Z https://www.soliforum.com/post/25392/#p25392 <![CDATA[Test print of cylinder... What should i configure next?]]> How is this looking? I'm not sure what to expect.

I've not done any xy or z configuration yet.

http://www.flickr.com/photos/97035392@N04/

Cheers

]]> https://www.soliforum.com/user/1769/ 2013-06-05T19:57:07Z https://www.soliforum.com/post/25391/#p25391