<![CDATA[SoliForum - 3D Printing Community — Print is stopping mid print.]]> 2013-05-29T12:40:37Z PunBB https://www.soliforum.com/topic/2599/print-is-stopping-mid-print/ <![CDATA[Print is stopping mid print.]]> I have been trying to print the same part twice now. Mid print it just stops extruding plastic and the feeding part on the head gets jammed and I have to take it apart and pull the old filament out and clip the end and re install. What do youy thing is happening?

I was printing .1mm with 50% infill every 3 layers at .3mm
The infill seemed to be struggling even at the start. Should I possibly decrease my retract setting for this?

My setup is a SD3.
plexiglass case(unfinished) - the top piece is just sitting in the top with the filament going through the small space between the top of the Z axis guide rods protruding out the top of the case. I thought this was casing the jam but I have printed several other things with no issues.
40mm cooling fan with duct on the print head. - Could this possibly be causing my tip to clog enough to cause a jam?

I have attached the STL and a picture of where it stopped.

]]> https://www.soliforum.com/user/1682/ 2013-05-29T12:40:37Z https://www.soliforum.com/post/24438/#p24438